Blog

Turning a directional vehicle count into Synchro volume inputs

Traffic signal heads and turn-lane direction signs mounted over a roadway against a clear sky

Synchro doesn't have a field for "northbound, 1,400 vehicles." It has a volume window with a cell for every movement: NBL, NBT, NBR, and the same three for every other approach. If what landed on your desk is a directional count off a corridor, that's useful raw material, but it's not ready to type in.

Why a directional count and a turning movement count aren't interchangeable

A directional count tells you how many vehicles passed a point on the link, split by travel direction. A turning movement count (TMC) tells you what those vehicles did when they hit the stop bar: went left, went straight, went right. Synchro, SimTraffic, and most capacity software built on the HCM methodology run on the second kind. You can't fake a TMC out of nothing, but you also don't need a full manual count at every intersection on the corridor to get there.

If the subject intersection has an archived TMC from a reasonably recent study, a nearby re-timing project, or a development traffic impact analysis, that's your starting point for turn splits even if the raw volumes are stale. If nothing exists, a short manual or video-based count at the handful of intersections that actually govern the corridor's level of service usually covers it. You don't need turn splits at every signal, just the ones where lane assignment and phasing decisions get made.

Building the movement volumes from directional counts

Once you have turn percentages, apply them to the directional link volume for that approach. Say the eastbound approach carries 820 vehicles in the peak hour and your reference TMC shows 15% left, 78% through, 7% right. That gives you roughly 123 left, 640 through, 57 right. Round to something sensible, not to the vehicle, and note in your file where the splits came from, because a reviewer will ask.

Do this for every approach at every study intersection before you open Synchro. Trying to split volumes inside the software while also building the network tends to produce errors nobody catches until the HCM report comes back with a v/c ratio that makes no sense.

Entering it into Synchro

In the Volume window (Intersection menu, then Volume, or the toolbar icon that looks like a four-leg diagram), each approach gets three movement cells plus PHF, growth factor, and heavy vehicle percent if you're adjusting for those. Lane utilization factors live in the Lane Group settings, not the Volume window itself, so don't try to force them in there.

Before you move to the next intersection, check that your movement volumes roughly reconcile with the directional link count between signals. Outbound volume from one intersection, minus whatever turns off into driveways or side streets, should land close to the inbound directional count at the next one. A corridor with evenly spaced signals and no major midblock access should balance within a reasonable margin. When it doesn't, either the turn splits are wrong, the directional count is from a different day than the TMC, or there's a driveway or unsignalized cross street eating volume you haven't accounted for. Catching that now is a lot cheaper than catching it after the timing plan is built around bad numbers.

Where the directional count comes from in the first place

All of this assumes you already have a directional count for the link. On an instrumented arterial that's a pull from an existing counter. On a link nobody has ever put a tube on, which describes most of the secondary and tertiary network in a typical capacity study, getting that number has usually meant scheduling a crew, closing a lane to lay tubes, or renting a radar unit for a week.

Vehicle Counting covers that gap from a different angle: one scheduled pass over the corridor, detected and counted, delivered as a CSV of counts by link and direction with the marked-up frame it came from. No tube to lay, no lane closure, just a directional tally for the link you were missing.

If a link in your study area has never had a count, that's a reasonable place to start.

Start a pilot